aurus dead boot recovery
After flash your mobile will not detect with computer and laptop ?
Follow this step :----
Requirement for repair your Device
1) Screwdriver (by which you can open the screw from handset)
2) Bricked device
3) Data cable for your Device
4) Copper wire (for sold test points)
5) Laptop or Computer with SPflash tool
6) mtk drivers and stock firmwere for your mobile
- now you have to disassemble your phone and take pcb out. check there should be some Golden points. check these points there should be written on them Rx, Tx, GND, Vcc, Vcharge etc.. check there should be written “COLO” or “KOLO” or“KCOLO” you have to Sold that point with GND After Sold Attach Data cable now your phone will detect with USB !.
- In some phones “COLO” or “KOLO” or “KCOLO” not written for those type of phones you have to test all points one by one Short Golden point with GND and attach Data cable which point short with gnd can able to detect your phone by Computer or Laptop is Force Pre-loader Mode Test Point.
- Keep in mind Don’t Short Vcc, Vcharge or any other pin which have 4.x Volts.
Comments
Post a Comment